JavaScript Menus and DHTML Menus Powered by Milonic
Wasabi Storage Builder® for iSCSI SAN features
Features
 

Supported Hardware
CPUs: Core2 or Xeon processor, Intel based motherboard with 5000 series chipset
or higher
- Motherboard must have a EIDE port for the Wasabi Disk on Module (DOM)
- LSI Logic 82xx, 87xx and 88xx series RAID controllers
- Hard drive with SATAII or SAS interface
- DDR,DDR2 Memory. ECC Registered memory recommended for reliability
Gigabit ethernet adapters and chips: Intel, Broadcom, and others
10 Gigabit Ethernet support: Myricom and Intel


iSCSI Support
Support Multiple Connections per Session (MC/s) CHAP (one-way and mutual)
LUN Masking
Error Recovery Levels (ERL) 0, 1, and 2
Header and Data Digest
iSNS and SLP
Software Initiators: Microsoft, linux-iSCSI, core-iSCSI, open-iSCSI, VMware ESX 3.5,
Netware, and SUN Solaris

Networking
Full IPv4 and IPv6
TCP Checksum and Segmentation Offload
Jumbo Frames
Active link indication
Network Time Protocol (NTP)


Volume Management Support
Supports greater than 2TB volumes support
Supports volumes and virtual disks of up to 18 exabytes (18 EB)
Spanning or RAID across multiple disk arrays
Up to 64 virtual disks (LUNs)

Storage Management
Multiple Snapshots
Support for Online Capacity Expansion
Software iSCSI Initiator
Management Browser-based Configuration / Monitoring Utility
E-mail Notification of logical disk and S.M.A.R.T. failures
Command line interface
Telnet support for accessing the CLI
Multiple Hardware RAID Controller Support


Wasabi RAID Levels
Levels 0, 1, 10, 5, 50, 6, 60 JBOD, and Span
Supports individual JBOD hard disks or RAID
HBA Logical Disks as RAID members

Certifications
Certified under VMWare ESX 3.5 

 

 

 

Wasabi Storage Builder iSCSI SAN
 
 
 
 
 
 
 
feedback    |   sitemap   |   home
Copyright © 1997-2009, All Rights Reserved. Unauthorized use prohibited.Legal Notices|Privacy Policy